Shimadzu ELB300 Instruction Manual download pdf (Page 31)

- 26 -

Recharging

the battery

Set the power switch to “OFF”. Insert the AC adapter plug into

the power jack of the balance, and insert the AC adapter into the

power outlet to start recharge.

Recharge is completed in 15 hours. Pull out the AC adapter from

the power outlet after 15 hours.

Turn off the power and disconnect the AC adapter plug from the

balance.

Remove the pan and pan supporter.

Remove the seal on the back of the balance.

While holding down the pan supporter shaft, screw the hook into

the screw hole on the bottom of the balance by hand. (Do not use

any tools such as a monkey wrench to tighten the hook, as it may

damage the sensor inside the balance.)

Place the balance at a place where no excess force is applied to

the hook.

Remount the pan supporter and pan onto the pan supporter shaft.

17.2 Below-Balance-Weighing Hook

With the below-balance-weighing hook, the sample can be suspended below the

balance for weighing. This is particularly useful for specific gravity measurements.

Attaching

(1)

the hook to

the balance

(2)

(3)

(4)

(5)

(6)

Below-balance-weighing hook

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

No comments

Shimadzu ELB300 Instruction Manual Page 31