Shimadzu ELB300 Instruction Manual download pdf (Page 19)

- Press the [ON/OFF(BREAK)] key to

abort calibration. “Abort” is displayed

and then the balance reverts to the

weight display.

Aborting is not possible while “End” is

being displayed.

10. Piece Counting

The ELB-series balance is capable of counting the number of pieces of the sample by measuring the

weight of a single piece of the sample.

The number of pieces to determine the weight of the single piece

can be selected from 10, 20, 50 and 100 (the larger the number of pieces, the higher the measurement

accuracy). The counted number of pieces is displayed with the unit “PCS”.

Setting procedure

(1)

(2)

(3)

(4)

(5)

(6)

Place the container on the pan and press the

[TARE] key.

Select piece counting mode (Conv PCS) in

menu selection, and press the [TARE] key.

(Refer to “5. Menu Selection”.)

The number of reference pieces “10” is

displayed. Select the intended number by

pressing the [MODE] key. The displayed

number changes in the following order: 10 ->

20-> 50 -> 100 -> 10…

Place the displayed number of sample pieces in the container while the number

of reference pieces is displayed.

Press the [TARE] key when the stability mark illuminates.

After “SEt” is displayed, it changes to the

piece counting display with the “PCS” mark

illuminating.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

No comments

Shimadzu ELB300 Instruction Manual Page 19